fluidnc
https://github.com/bdring/fluidnc
C++
The next generation of motion control firmware
Triage Issues!
When you volunteer to triage issues, you'll receive an email each day with a link to an open issue that needs help in this project. You'll also receive instructions on how to triage issues.
Triage Docs!
Receive a documented method or class from your favorite GitHub repos in your inbox every day. If you're really pro, receive undocumented methods or classes and supercharge your commit history.
C++ not yet supported1 Subscribers
Add a CodeTriage badge to fluidnc
Help out
- Issues
- Feature: Support for spindels with dedicated start and stop signal
- Feature: Implement M66 not-immediate modes
- Problem: Modbus RS485 frame misalignment
- Feature: Disable Motor/Stepper automatically after fault/estop/hard stop
- Problem: Fluid Dial interferes with FluidNC when it runs gcode
- Problem: v4.0.0-pre2 WIFI mode AP ESP32 WEBUI3 timeouts
- Problem: ESP32-S3 I2SO on GPIO7/15/16: stepper enable outputs stay low (0V) and motors don’t move (custom board)
- Problem: BUG Fix FluidNC/src/Kinematics/ParallelDelta.cpp Line 291 should read return false; instead of just false;.
- Problem: software stays in loop, not possible to connect to wifi and get's stuck
- Problem: Job crashes upon Wifi disconnect
- Docs
- C++ not yet supported